Click here to make a booking or an inquiry
Click here to get us to call you back

Popcorn Machine Hire Operating Instructions

Below you will find instructions on how to operate our Popcorn MachineBe sure the popcorn machine is connected to 240 volt power.

Popping

  1. Turn on the two switches.
  2. Allow kettle to warm for approximately 5 minutes
  3. Place the oil and the kernels together in the kettle. Pull kettle lid closed to prevent stray kernels. (Lid is held in place by a magnet directly above the kettle)
  4. While popcorn is popping, keep front operator doors slightly ajar to prevent fogging. Keep hopper door at 'out' position to aid in catching stray popcorn.
  5. Allow popcorn to pop until popping ceases, usually when 3-4 seconds lapse between pops. Then pour remaining popped corn from kettle by rotating handle clockwise 1/3 turn and pulling downward.
  6. Repeat steps 1 - 5 for additional batches.
  7. Turn KETTLE switch to OFF position when finished preparing popcorn; POWER or LIGHT switch may remain ON to display and heat the popcorn.
KETTLE WILL BE HOT! Please be sure to avoid direct contact with the kettle during the popping process!

Cleaning the Popcorn Machine

Note: To avoid heavy build-up of deposits that require specialised cleaning, please follow these instructions:

  1. Wipe, with soft towel or cloth, excess oil from the kettle and interior of the popcorn machine as often as possible.
  2. Excessive or careless use of oil may result in kettle damage.
  3. Always be sure to turn KETTLE switch to OFF when popping is complete.
  4. NEVER USE WATER ON ANY PART OF THE KETTLE!